| Hourly Labor
Rate $ 75.00
Balance Rotating Assembly $ 255.00
Bore Block(V8) $ 150.00
Bore Block (6 Cyl) $ 20.00 ea hole
Bore Block (4 Cyl) $ 25.00 ea hole
Bore Block w/Torque Plate $ 225.00
Check Main Bore $ 37.50
Clean Tinware $ 37.50
Crank Exchange $105.00
Cut Seats $ 5.00 each
Disassemble Short Block $ 75.00
Grind Flywheel $ 35.00
Grind Seats $ 3.00 each
Grind Valves $ 3.00 each
Hone Block $ 75.00
Hone Fit Guides $ 2.00 each
Hot Tank Block $ 50.00
Install Exhaust Seats $ 8.00 each
Install K-Line Guides $ 4.00 each
Install Cam Bearings $ 37.50
Line Hone Block $175.00
Mount Pistons $ 6.00 each
Polish Crank Shaft $ 37.50
R & R Pistons $ 40.00
Reassemble Short Block $ 325.00
Recondition Rods $ 12.00 each
Resize Rods $ 12.00 each
Resize Rods & Bolts $150.00
Surface Block $125.00
Surface Block w/BHJ Fixture $150.00
Surface Intake Manifold $ 75.00/side
Surface Head $ 35.00
Surface Pair of Heads $ 50.00
Thermo Clean & Mag Block $ 50.00
Thermo Clean & Mag Heads $ 50.00
Vacuum Test/Pressure Test Heads $ 25.00 each
Wash Block $ 35.00
Wash Head $ 7.50 each
Wash Intake Manifold $ 35.00
Grind Crankshaft $105.00
Reground Crank Kit (includes crank, rods & mains)
$150.00 (Based on SBC)
|
REBUILT HEADS
(includes guides, surface, clean & mag &
valve Job)
(Does not include valves or any other parts that may be necessary)
V-8 & V-6 $ 270.00 + parts
4 Cyl OHV $ 190.00 + parts
4 Cyl OHC No Cam $ 205.00 + parts
4 Cyl OHC w/Cam $ 210.00 + parts
4 Cyl OHC W/Pucks $ 280.00 + parts
V-6 OHC W/Pucks $ 425.00 + parts
V-8 Diesel $ 375.00 + parts
4 Cyl Diesel $ 255.00 + parts
4 Cyl 16V Dual Cam $ 310.00 + parts
4 Cyl 2.3 & 2.0 Ford $ 255.00 + parts
3.0 Chrysler $300.00 + parts
3VZE Toyota $ 450.00 + parts
ENGINE DYNONOMETER
Standard Dyno $450.00 and Up
Dyno with Nitrous $500.00 and Up
|
